Faris Al-Jamal
Analysis of the Aerodynamic Performance of a Small-Scale Vertical Axis Wind Turbulne using OpenFOAM with a Focus on the Shaft Roughness
Tag der Abgabe: 24.04.2023
Sadaf Asmatullah (Master Thesis)
Normenmodelle für die Böenerregung von Längs-und Querschwingungen schlanker Bauwerke
Tag der Abgabe: 11.04.2023
Md Arifuzzaman
Analysis of Large Eddy Simulations of flow patterns and wind energy potential above high-rise buildings
Tag der Abgabe: 01.04.2023
Alireza Hajji Malayeri
Flow modelling with CFD in wastewater tanks with resolved real mixers´ geometry
Tag der Abgabe: 26.01.2023
Ganesh Chockalingam (Master thesis)
Characterization of in-canopy wind profile using CFD simulations - A data-driven approach
Tag der Abgabe: 15.04.2022
Satish Kumar Narayanan (Master Thesis)
Synthetic Turbulence Generation in Atmospheric Boundary Layers for LES of Building Aerodynamics
Tag der Abgabe: 23.02 2022
Begleitung: Dipl.-Ing. Ulf Winkelmann
Qyteti Klidi (Master Thesis)
Validation of numerically calculated near-ground flow and concentration fields within a group of buildings using Wind Tunnel data
Tag der Abgabe: 09.02.2022
Julius Gerlach (Master Thesis)
Simulation von Temperatur-, Konzentrations- und Strömungsfeldern bei Brandereignissen in Straßentunneln mittels numerischer Strömungsmechanik
Tag der Abgabe: 17.05.2021
Begleitung: Dr.-Ing. Cornelia Kalender
Ika Kurniawati (Master Thesis)
Numerical investigation of interference effects on circular cylinders in the transcritical range of Reynolds numbers
Tag der Abgabe: 07.01.2021
Begleitung: Dr.-Ing. Francesca Lupi
Anja Raida (Master Thesis)
Numerische Untersuchung des Einflusses verschiedener Randbedingungen auf die Stoffausbreitung in einem fiktiven Stadtmodell
Tag der Abgabe: 15.04.2020
Mark Schmidt (Master Thesis)
Eignung des 3D-Rapid-Prototype-Drucks für maßstäbliche Windkanalmodelle
Tag der Abgabe: 13.03.2020
Joshi Saurav (Master Thesis)
Numerical analysis of the wind flow and sand / dust transport on the collector surface of a solar upwind power plant
Tag der Abgabe: 01.03.2020
Begleitung: Dr.-Ing. Cornelia Kalender
Mazen Draw (Master Thesis)
Validation of RANS simulations of surface pressure at cuboids in turbulent boundary layer flow
Tag der Abgabe: 27.05.2019
Volodomyr Zinnkevych (Master Thesis)
Wirkung verschiedener Turbulenzgeneratoren bei quasi-stationären und zeitauflösenden numerischen Strömungsberechnungsverfahren (CFD) in der Bauwerksaerodynamik
Tag der Abgabe: 06.05.2019
Ahmad M. Ghani (Master Thesis)
Monitoring data based investigation of consumed life time for an operating wind turbine support structure
Tag der Abgabe: 13.10.2018
Begleitung: M.Sc. Simon Tewolde
Lisa Pieper (Master Thesis)
Wind tunnel tests on vortex induced vibrations and galloping of models with different rectangular cross sections
Tag der Abgabe: 28.09.2018
Begleitung: Dipl.-ing. Ulf Winkelmann, Dr.-Ing: Francesca Lupi
Jean M. B. Graterol (Master Thesis)
Modelling of cavitation-induced air release in orifice water flows
Tag der Abgabe: 04.06.2018
Christian Böhmeke (Master Thesis)
Numerische und experimentelle Analyse von Winddrücken an einem Turmdach des Schlosses Friedenstein in Gotha
Tag der Abgabe: 07.05.2018
Begleitung: Dipl.-Ing. Ulf Winkelmann
Nadine Schulte (Master Thesis)
Einfluss der Windlasteinzugsfläche und des geometrischen Maßstabs von Windkanalmodellen auf die Spitzenwerte der Außendrücke
Tag der Abgabe: 02.05.2018
Rohit Balasubramanian (Master Thesis)
Numerical Investigation of Pollution Dispersion in a Virtual City
Tag der Abgabe: 03.04.2018
Begleitung: Dr.-Ing. Cornelia Kalender
Simon Kosse (Master Thesis)
Assesing the impact of manufacturing variations on turbine vane stress levels with adjoint methods
Tag der Abagbe: 03.04.2018
Ajitkumar A. Jeyakumar (Master Thesis)
Comparison and Evaluation of Multiple CFD Wheel Simulation Methods and its Correlation to Wind Tunnel Test Results and Flow Fields
Tag der Abgabe: 23.02.2018
Begleitung: Dipl.-Ing. Ulf Winkelmann
Pohl, Sven Michael (Master Thesis)
Entwicklung eines nichtlinearen Anpassungsalgorithmus für das Erstellen von Fundamentalgleichungen und seine Anwendungen am Beispiel des Lennard-Jones Modellfluids
Tag der Abgabe: 22.11.2017
Peng Lyu (Master Thesis)
Applcicability of RANS simulations for the modeling oa aerodynamic drag and pressures around circular cylinders with surface roughness for turbulent flows
Tag der Abgabe: 14.11.2017
Lubna Makhool (Master Thesis)
Experimental investigation and numerical simulations of non-Newtonian flow of bentonite suspensions through porous media based on a pore space description from uCT analysis
Tag der Abgabe: 28.08.2017
Anna S. Giskes (Master Thesis)
Sensitivität der strömungsmechanischen Modellierung von Abflusskonzentration mit Hilfe eines 2D-Modells
Tag der Abgabe: 31.07.2017
Zishan Naveed (Master Thesis)
Sensitivity of Modal Parameters to structural changes applied to FE Model of an offshore wind turbin support structure
Tag der Abgabe: 27.04.2017
Begleitung: M.Sc. Simon Tewolde
Ana Cvetkovic (Master Thesis)
Spectral analysis of wind turbulence induced oscillations of line like structures
Tag der Abgabe: 25.04.2017
Begleitung: MSc. Simon Tewolde
Mohammed A. Shadrokh (Master Thesis)
Required support pressure in fractured rock mass under groundwater tabke for EBP drives
Tag der Abgabe: 30.03.2017
Abhishek R. Kulkarni (Master Thesis)
Influence of the approaching flow on flow behavior around a high-rise building for LES
Tag der Abgabe: 11.01.2017
Tara Pouyafar (Master Thesis)
Experimentelle Ermittlung von windinduzierten Oberflächendrücken zur statischen und dynamischen Analyse von großformartigen Parabolrinnenmodulen
Tag der Abgabe: 29.12.2016
Begleitung: Dipl.-ing. Ulf Winkelmann, M. Sc. C. Kämper
Nabeel Safdar (Master Thesis)
Forced Response Analysis of a Shrouded Turbine Stage Including Two Different Transient Blade-Row Models and a Detailed Non-Linear Structural Analysis
Tag der Abgabe: 12.10.2016
Begleitung: B. Winhart
Jenny Arne (Master Thesis)
Hybride Modellierung von Würfelumströmungen als Optimierungsgrundlage für die Positionierung von Kleinwindenergieanlagen an kubischen Gebäudekörpern
Tag der Abgabe: 18.07.2016
Begleitung: Dipl.-ing. Ulf Winkelmann, Dr.rer. Nat. W. Vogelmann
Sönke Dellschaft (Master thesis)
Vorstudie zur entwicklung eines Windkanalmodells fr einen H-Darrieus Rotor
Tag der Abgabe: 14.12.2015
Praful Prabhuaro (Master Thesis)
Performance study of a supersonic two-stage and a transonic stage fan using ANSYS CFX
Tag der Abagbe: 10.12.2015
Begleitung: M.Sc Senad Iseni
Renate Pelcer (Master Thesis)
Validation of numerical simulations of turbulent atmospheric flow past a square wall-mounted cube
Tag der Abgabe: 12.10.2015
Vanessa Saubke (Master Thesis)
Numerische Simulation des Innendrucks von windexponierten Bauwerken
Tag der Abgabe: 30.09.2015
Begleitung: Dr.-Ing. Cornelia Kalender, Dipl.-Ing. Ulf Winkelmann
Pramod M. Mohan (Master Thesis)
Aerodynamics of a Brigde Deck using LES: Numerical and Experimental Validation
Tag der Abgabe: 15.09.2015
Begleitung: Dipl.-ing. Ulf Winkelmann
Mohit Sharma (Master Thesis)
Parallelization of Component Mode Synthesis, Using Characteristic Constraint Modes, for a Large Free-Standing Aluminum Roof Structure
Tag der Abgabe: 12.11.2014
Deniz Sevgi (Master Thesis)
Numerical Simulation of Turbulent Flow Past a square Bluff Body
Tag der Abgabe: 31.10.2014
Begleitung: Dipl.-ing. Ulf Winkelmann
Bekir Kutaya (Master Thesis)
Erstellung einer Potentialflächenanalyse, Layoutplanung, Ertragsabschätzungen und Wirtschaftlichkeitsprüfungen für ein Gemeindegebiet in Deutschland
Tag der Abgabe: 28.10.2014
Kristina Tscheplanski (Master Thesis)
Versuchsbasierte Ermittlung von Druckbeiwerten für die statische Bemessung von Parabolrinnen
Tag der Abgabe: 10.04.2014
Niraj Kumar (Master Thesis)
Numerical Modelling of Axial Ventilator Fans for Headlamp Applications
Tag der Abgabe: 14.02.2014
Marhajan Sarat (Master Thesis)
Structural analysis of a curved light-weight noises barrier wall with transparent elements with particular consideration of dynamic actions due to high speed trains
Tag der Abgabe: 13.02.2014
Begleitung: Dr.-Ing. Nobert Hölscher
Prateek Ananthaprasad (Master Thesis)
Numerical Simulation of Exhaust system using Fluid structure coupling
Tag der Abgabe: 29.10.2013
Gülacar Dogan (Master Thesis)
Numerical Flow Simulations of a Centrifugal Pump with OpenFOAM
Tag der Abgabe: 07.06.2013
Bastian Stahra (Master Thesis)
Numerische Strömungssimulation der Winddrücke an Photovoltaikmodulen einer Freifeldanlage
Tag der Abgabe: 07.04.2013
Begleitung: Dipl.-Ing C.Kalender-Wevers
Inga Ellerkmann (Master Thesis)
Schallprognosen bei Windparkplanungen Vergleich und Durchführungen verschiedener Berechnungsmethoden
Tag der Abgabe: 31.03.2013
Lena Ria Vorspel (Master Thesis)
Zur Netzabhängigkeit bei der numerischen Simulation von Staubausbreitungen in der Windströmung um Gebäude-Diskretisierungsfehlerbestimmung mittels Richardson Extrapolation
Tag der Abgabe: 28.01.2013
Begleitung: Dipl.-Ing C. Kalender
Abdul Wahhab (Master Thesis)
In-Cabin Airflow and Defrost Analysis of Passenger Car
Tag der Abgabe: 31.10.2012
Tilmann Schölhammer (Diplomarbeit)(Master Thesis)
Wirkung der Elektromobilität auf die Luftqualität im innerstädtischen Gebiet
Tag der Abgabe: 10.09.2012
Begleitung: Prof. Dr.-Ing. R. Höffer, Dipl.-Ing C. Kalender-Wevers, Dr. Sabine Wurzler
Burak Özarmut (Master Thesis)
Meshing Strategies for Consideration of Random Fields in Non-linear Finite Element Analysis
Tag der Abgabe: 03.05.2011